IDK MSD-54 Series Command Guide - Manual (Page 116)

MSD-54 Series Users Guide (Command Guide)
116
@ECA Edit audio channel setting in cross point memory
Command
format @ECA, memory, a_1 (, a_2, a_3, a_4 )
Return value
format @ECA, memory, a_1 (, a_2, a_3, a_4 )
Parameter memory : Cross point memory
1 to 9
a_1-4 : Audio output
-1 = Not controlled, 0 = OFF, 1 = IN1 to 9 = IN9
Example Send
Receive
@ECA,2,1,2,3,-1
@ECA,2,1,2,3,-1 If cross point memory 2 is loaded, OUT1 to 3 are
set IN1 to 3, respectively, and OUT4 is not
controlled.
Related info. 8.13.3 Editing cross point
@GCA Get audio channel setting in cross point memory
Command
format @GCA, memory
Return value
format @GCA, memory, audio_1 (, audio_2, audio_3, audio_4), name
Parameter memory : Cross point memory
1 to 9
audio_1-4 : Audio output
-1 = Not control, 0 = OFF, 1 = IN1 to 9 = IN9
Nothing is saved in the memory as factory default, the state is “-1” (Not controlled)..
If you save only video (@SCV) at the first saving of cross point settings, “-1” (Not
control) is replied for unsaved audio.
name : Memory name
Up to 10 characters using 20 to 7D. “2 ASCII codes”
Example Send
Receive
@GCA,2
@GCA,2,3,1,2,4
PATTERN2
Get audio channel of cross point memory 2.
With the name, “PATTERN2”, the following settings
are saved: OUT1: IN3; OUT2: IN1; OUT3: IN2;
OUT4: IN4.
Related info. 8.13.3 Editing cross point
@RPM Load all settings from preset memory
Command
format @RPM, preset
Return value
format @RPM, preset
Parameter preset : Preset memory
1 to 8
Example Send
Receive
@RPM,3
@RPM,3
Load preset memory 3.
Terminated normally.
Send
Receive
@RPM,7
@ERR,3
Preset memory without registered data cannot be
loaded.
Related info. 8.13.4 Loading all settings
Caution Once you execute this command, all settings of video and audio I/O except some
environmental settings are updated.