IDK MSD-54 Series Command Guide - Manual (Page 54)

MSD-54 Series Users Guide (Command Guide)
54
@GIS Get automatic measurement of start position
Command
format @GIS
Reply
command @GIS, in_6, in_7, in_8, in_9
Parameter in_6-9 : Automatic measurement of each input channel
0 = All inputs from this input channel are not measured automatically
1 = Current input signals are not measured automatically
2 = Current input signals are measured automatically. [Default]
Example Send
Receive
@GIS
@GIS,0,1,1,1
Get automatic measurement of starting position.
IN6: Not measured automatically; other inputs:
measured automatically.
Related info. 8.6.7 Automatic measurement of start position
@SSM Set automatic setting of input timing
Command
format @SSM, mode
Return value
format @SSM, mode
Parameter mode : Automatic measurement
0 = Not execute, 1 = Execute [Default]
Example Send
Receive
@SSM,1
@SSM,1 Execute automatic measurement if unregistered signals
are input.
Terminated normally.
Related info. 8.6.8 Automatic setting of input timing
@GSM Get automatic setting of input timing
Command
format @GSM
Return value
format @GSM, mode
Parameter mode : Automatic measurement
0 = Not execute, 1 = Execute [Default]
Example Send
Receive
@GSM
@GSM,1
Get automatic measurement mode when unregistered
signals are input.
Execute automatic measurement when unregistered
signals are input.
Related info. 8.6.8 Automatic setting of input timing