IDK MSD-54 Series Command Guide - Manual (Page 50)

MSD-54 Series Users Guide (Command Guide)
50
@SHS Set horizontal start position
Command
format @SHS, ch, h_start
Return value
format @SHS, ch, h_start
Parameter ch : Input channel
0 = All inputs, 1 = IN1 to 9 = IN9
h_start : Start position of horizontal fetch
64 to 2900 ([The total number of horizontal dots - Horizontal display period] or
less)
[Default]: Differs depending on input signals
Example Send
Receive
@SHS,5,296
@SHS,5,296
Set horizontal starting position of IN5 to 296.
Terminated normally.
Send
Receive
@SHS,6,296
@ERR,3
If no signal is input, an error is replied.
Related info. 8.6.2 Horizontal start position
Note This command is valid only if signals are input.
@GHS Get horizontal start position
Command
format @GHS
Return value
format @GHS, in_1, in_2, in_3, in_4, in_5, in_6, in_7, in_8, in_9
Parameter in_1-9 : Starting position of horizontal shift of each input channel
64 to 2900 ([The total number of horizontal dots - Horizontal display period] or
less)
[Default]: Differs depending on input signals
Example Send
Receive
@GHS
@GHS,192,192,496,0,296,
0,378,378,0
Get horizontal starting position.
0 is replied to channels without input
signals.
Related info. 8.6.2 Horizontal start position
@SHD Set horizontal display period
Command
format @SHD, ch, h_disp
Return value
format @SHD, ch, h_disp
Parameter ch : Input channel
0 = All inputs, 1 = IN1 to 9 = IN9
h_disp : Horizontal display period
64 to 2900 ([The total number of horizontal dots - 64] or less)
[Default]: Differs depending on input signals
Example Send
Receive
@SHD,5,1024
@SHD,5,1024
Set horizontal display period of IN5 to 1024.
Terminated normally.
Send
Receive
@SHD,6,1024
@ERR,3
If no signal is input , an error is replied.
Related info. 8.6.3 Horizontal display period
Note This command is valid only if signals are input.