IDK MSD-54 Series Command Guide - Manual (Page 117)

MSD-54 Series Users Guide (Command Guide)
117
@SPM Save all settings in preset memory
Command
format @SPM, preset (, name)
Return value
format @SPM, preset (, name)
Parameter preset : Preset memory
1 to 8
name : Memory name
Up to 10 characters using 20 to 7D. “2 ASCII codes”
If you do not specify memory name, only each setting is saved without changing the
memory name
Example Save current settings in preset memory 2.
Send
Receive
@SPM,2
@SPM,2
Not specify memory name
Send
Receive
@SPM,2,MEMORY2
@SPM,2,MEMORY2 Specify memory name
Related info. 8.13.5 Saving all setting
@SMU Set startup setting
Command format @SMU, state
Return value
format @SMU, state
Parameter state : Startup setting
1 to 9 = Cross point memory 1 to 9, 10 = Channel OFF,
11 = Last channel [Default], 12 to 19 = Preset memory 1 to 8
Example Send
Receive
@SMU,3
@SMU,3
Set startup channel setting to cross point memory 3.
Terminated normally.
Related info. 8.13.6 Startup setting
@GMU Get startup setting
Command format @GMU
Return value
format @GMU, state
Parameter state : Startup setting
1 to 9 = Cross point memory 1 to 9, 10 = Channel OFF,
11 = Last channel [Default], 12 to 19 = Preset memory 1 to 8
Example Send
Receive
@GMU
@GMU,3
Get startup status.
Channel setting saved in cross point memory 3 is
applied at start up.
Related info. 8.13.6 Startup setting