IDK MSD-54 Series Command Guide - Manual (Page 51)

MSD-54 Series Users Guide (Command Guide)
51
@GHD Get horizontal display period
Command
format @GHD
Return value
format @GHD, in_1, in_2, in_3, in_4, in_5, in_6, in_7, in_8, in_9
Parameter in_1-9 : Horizontal display of each input channel
64 to 2900 ([The total number of horizontal dots - 64] or less)
[Default]: Differs depending on input signals
Example Send
Receive
@GHD
@GHD,1920,1920,0,1920,
1024,1360,0,1360,0
Get horizontal display lines.
0 is replied to channels without input
signals.
Related info. 8.6.3 Horizontal display period
@SVS Set vertical start position
Command
format @SVS, ch, v_start
Return value
format @SVS, ch, v_start
Parameter ch : Input channel
0 = All inputs, 1 = IN1 to 9 = IN9
v_start : Vertical starting position
10 to 2048 ([The total number of vertical lines - Vertical display period] or less)
[Default]: Differs depending on input signals
Example Send
Receive
@SVS,5,35
@SVS,5,35
Set vertical starting position of IN5 to 35.
Terminated normally.
Send
Receive
@SVS,6,35
@ERR,3
If no signal is input , an error is replied.
Related info. 8.6.4 Vertical start position
Note This command is valid only if signals are input.
@GVS Get vertical start position
Command
format @GVS
Return value
format @GVS, in_1, in_2, in_3, in_4, in_5, in_6, in_7, in_8, in_9
Parameter in_1-9 : Vertical starting position of each input channel
10 to 2048 ([The total number of vertical lines - Vertical display period] or less)
[Default]: Differs depending on input signals
Example Send
Receive
@GVS
@GVS,40,0,40,40,35,0,
24,24,0
Get vertical starting position.
0 is replied to channels without input signals.
Related info. 8.6.4 Vertical start position