IDK MSD-54 Series Command Guide User Manual

Page 85

MSD-54 Series Users Guide (Command Guide)

@SLF

Set LAN operation mode

Command
format

@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)

Return value
format

@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)

Parameter

connection

: Connection number

1 = Connection 1 to 8 = Connection 8

mode

: Operation mode

0 = RECEIVER mode [Default], 1 = TRANSMITTER mode

ip_1

: Upper bit of the destination IP address to ip_4 : Lower bit of the destination IP

address

0 to 255 = 8 bit (Decimal notation) [Default]: 192.168.001.200

Set this parameter only if you select TRANSMITTER mode above.

pjlink

: PJLink protocol connection

0 = PJLink not used [Default], 1 = PJLink used

Set this parameter only if you select TRANSMITTER mode above.

tcp

: Destination port number

1 to 65535 [Default]: 1100

Set this parameter only if you select TRANSMITTER mode and “0” (PJLink not used)
for pjlink above.

password

Up to 32 characters of the following ASCII codes: 30 to 39, 41 to 5A, 61 to 7A
(alphanumeric characters). “2ASCII codes”

Set this parameter only if you select TRANSMITTER mode and “1” (PJLink used) for
pjlink

above.

If you do not use password authentication to connect the device using PJLink
protocol, you can skip this parameter.

Example Send

Receive

@SLF,1,0

Set operation mode of connection 1
to RECEIVER.
Terminated normally.

Send

Receive

@SLF,2,1,192,168,1,1,0,1300

@SLF,2,1,192,168,1,1,0,1300

Set connection 2 as follows:
Option mode: TRANSMITTER,
Destination IP address: 192.168.1.1,
PJLink: Not used, Destination port
number: 1300
Terminated normally.

Send

Receive

@SLF,3,1,192,168,1,2,1,PROJE
CTOR1

Set connection 3 as follows:
Operation mode: TRANSMITTER,
Destination IP address: 192.168.1.2,
PJLink: Used, Password:
PROJECTOR1
Terminated normally.

Send

Receive

@SLF,3,1,192,168,1,2,1

Set connection 3 as follows:
Operation mode: TRANSMITTER,
Destination IP address: 192.168.1.2,
PJLink: Used, Password
authentication: Off
Terminated normally.

Related info.

8.11.4 Operation mode