IDK MSD-54 Series Command Guide - Manual (Page 73)

MSD-54 Series Users Guide (Command Guide)
73
@SAT Set test tone
Command format @SAT, ch_1, tone_1, speaker_1 (, ch_2, tone_2, speaker_2･･･)
Return value
format @SAT, ch_1, tone_1, speaker_1 (, ch_2, tone_2, speaker_2･･･)
Parameter ch_1-4 : Output
0 = All outputs, 1 = OUT1 to 4 = OUT4
tone_1-4 : Test tone
0 = OFF [Default], 1 = 1 kHz, 2 = 400 Hz
speaker_1-4 : Speaker
0 = ALL [Default], 1 = FRONT L/R, 2 = REAR L/R,
3 = REAR L/R CENTER, 4 = FRONT LEFT, 5 = FRONT RIGHT,
6 = LOW FREQUENCY EFFECT, 7 = FRONT CENTER, 8 = REAR LEFT,
9 = REAR RIGHT, 10 = REAR LEFT CENTER, 11 = REAR RIGHT
CENTER
Example Send
Receive
@SAT,1,1,0
@SAT,1,1,0
Output 1-kHz test tone to all speakers of OUT1.
Terminated normally.
Related info. 8.8.10 Test tone
@GAT Get test tone
Command format @GAT
Return value
format @GAT, t_out_1, s_out_1 (, t_out_2, s_out_2, t_out_3, s_out_3, t_out_4,
s_out_4 )
Parameter t_out_1-4 : Test tone of each output channel
0 = OFF [Default], 1 = 1 kHz, 2 = 400 Hz
s_out_1-4 : Speaker
0 = ALL [Default], 1 = FRONT L/R, 2 = REAR L/R,
3 = REAR L/R CENTER, 4 = FRONT LEFT, 5 = FRONT RIGHT,
6 = LOW FREQUENCY EFFECT, 7 = FRONT CENTER, 8 = REAR LEFT,
9 = REAR RIGHT, 10 = REAR LEFT CENTER, 11 = REAR RIGHT
CENTER
Example Send
Receive
@GAT
@GAT,2,1,0,0,0,0,0,
0
Get output settings of test tone
OUT1: 400-Hz test tone to FRONT L/R;
other outputs: No test tone
Related info. 8.8.10 Test tone