Adept s800 s800 - Manual (Page 70)

Chapter 5: Maintenance
l
The screen will display the number of degrees that each joint is expected to move
during the verification process.
l
You can click Preview Motions on this screen to view the motions at slow speed.
The default speed is 10, but you can change that speed with this screen's speed
control.
l You can click Move to Ready, to move the robot to the Ready position.
The robot will move each joint, in succession. It will generate an over-speed
condition for each, and verify that the hardware detected the over-speed
condition.
4. Click Next, to proceed to the Manual Mode Procedure.
If the Automatic Mode Procedure fails, you will not be allowed to proceed with the
Manual Mode.
Manual Mode Procedure
The manual mode of this verification requires the use of an Adept pendant.
For this verification, the Front Panel keyswitch must be in Manual mode.
1. From the Introduction screen, click Next.
l
Set the pendant to Joint mode.
l
Set the pendant manual control speed to 100.
2. Click Next.
3. Using the pendant, jog any of the robot's joints until power is disabled.
This indicates that the Teach Restrict function is working.
4. Click Next.
The results of the verification will be displayed.
5. Click Finish.
6. Reboot the SmartController.
On some systems, the SmartController will reboot automatically.
7. Reset the Front Panel keyswitch to Auto mode.
5.9 Replacing the Encoder Battery Pack
The data stored by the encoders is protected by a 3.6 V lithium backup battery located on the
fan bracket inside the base of the robot.
CAUTION: Replace the battery pack only with a 3.6 V,
6.8 Ah lithium battery pack, Adept P/N 09977-000.
Battery information is located in the base of the robot.
Adept Cobra s800 Inverted Robot User's Guide, Rev H1
Page 70 of 142