BNC 7000 Series User Manual - Manual (Page 52)

52
7 Maintenance and Warranty Information
7.1 Adjustments and Calibration
To maintain optimum measurement performance, the SERIES 7000 should be calibrated every
24 months. It is recommended that the SERIES 7000 be returned to Berkeley Nucleonics or to an
authorized calibration facility. For more information please contact our Customer Service Department
at support@Berkeley Nucleonics.com or through our website.
7.2 Repair
The instrument contains no user-serviceable parts. Repair or calibration of the SERIES 7000 requires
specialised test equipment and must be performed by Berkeley Nucleonics or its authorized repair
specialists.
7.3 Upgrading the Firmware via LAN
It is recommended to regularly check for new firmware for the SERIES 7000. If new firmware is
available, it can be downloaded from the Berkeley Nucleonics website and locally stored. Then, it can
be uploaded directly to the instrument via Device  Upload Firmware
7.4 Safety
FCC notice
This equipment has been tested and found to comply with the limits for a Class A device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference. In which case the
user will be required to correct the interference at his or her own expense.
notice
The SERIES 7000 meets the intent of the EMC directive 89/336/EEC and have been designed to
EN61326 Class A Emissions and Immunity standard.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com