BNC 7000 Series User Manual User Manual
Page 36
36
Besides programming of the external power supplies, there is a section called “Sampling
configuration”. In this section, the oversampling factor can be set. This factor determines the FFT
resolution of the measured trace. Per default the oversampling factor is two. The measurement time is
directly affected by the oversampling factor. A higher oversampling factor gives better frequency
resolution in the FFT and allows analyzing more details of spurious response.
Additionally, individual number of correlations can be set for the measurement decades using the
sliders on the left.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: