BNC 7000 Series User Manual - Manual (Page 22)

22
3.3 Measurement Tabs
The following tabs (each corresponding to a particular measurement mode), are available:
• Absolute Phase Noise,
• Additive Phase Noise, Amplitude Noise (SERIES 7000 only),
• Time Domain Analyzer (MODEL 7300 and MODEL 7070),
• FFT Analyzer.
Clicking on a tab will lead to the corresponding measurement setup. The following sections describe
each measurement tab and how to configure it to successfully perform a measurement.
3.3.1 General Tab Organization
In general, each measurement tab is organized in two sections, a SETUP and a PLOT section.
The SETUP section in the upper left corner is used to configure a particular measurement.
The PLOT section is used to display and post-process measured data. This section can be further
sub-divided in a Marker, and Trace and a Display window.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com