beautypg.com

Hanging cable location, Hawkjaw location – Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 User Manual

Page 9

background image

Hanging Cable Location

1. Anchor the hanging cable to a point as

close to the derrick crown as possible.
The longer the hanging cable, the easier
the HawkJaw is to move on and off the
drill pipe.

2. Locate the cable hang point as high

above the center of the rotary table as
possible. The cable must hang within
2'-3' ft. of the rotary table center.

Installation

9

Installation

NOTE

The hanging cable must permit the
HawkJaw to move from the drill pipe
connection to the mouse hole connection to
the HawkJaw rest position (3'- 5' ft. away
from the rotary table).

HawkJaw Location

1. Place the HawkJaw on the side of the

rotary table away from the setback
zone
. This allows the drill pipe stands
to swing straight from pick-up to
stabbing.

2. If possible, place the HawkJaw on the

opposite side of the setback zone. If
the rig has dual setback zones, Step 1
applies.

3. The HawkJaw may rest on the rig floor

3' -5' ft. away from the rotary table.