Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 - Manual (Page 56)

56 Maintenance & Repair
Changing the Torque Cylinder
15. Use air pressure or manual force
to extend the new Torque
Cylinder Rod to the length of the
old Torque Cylinder Rod.
16. Place the Bottom Trunion Mount
Plate (BMP) and Top Trunion
Mount Plate (TMP) on the new
Torque Cylinder.
17. Slide in the new Torque
Cylinder.
18. Use the 1 1/8" wrench to replace
the Bottom Torque Cylinder
Mount Bolts (BB). Use new
Lock Washers and red loctite
when replacing the Bottom
Torque Cylinder Mount Bolts
(BB). Assemble the Lock
Washers as shown.
19. Use the 1 1/8" wrench and 5/8"
Allen wrench to replace the Top
Torque Cylinder Mount Bolts
(TBH), (TBA). Use new Lock
Washers and red loctite when
replacing the Top Torque
Cylinder Mount Bolts (TBH),
(TBA). Assemble the Lock
Washers as shown.
20. Connect the Low Torque
Warning System Hydraulic Hoses
(HH &HH1).
HH1
HH
BB
C
CH2 CH1
TBA TBH
RH SC P
BMP TMP