Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 - Manual (Page 29)

Break Out
T
Operation
29 Operation
1. Rotate the Selector Switch (SS)
clockwise to the break position.
2. Push in the Grip Hold (GH)
button.
3. Push and hold in the wrench Grip
(G).
4. Push and hold down Torque (T).
5. When break out occurs, release
Torque (T). Immediately release
the wrench Grip (G). See note
below.
6. Press and hold down Spin (S)
until the stand pops out of the
connection. Release Spin (S). If
the stand will not spin, release
Spin (S). Repeat Steps 4-6.
7. Pull out the Grip Hold (GH)
button.
8. You are now able to remove the
Hawkjaw from the pipe.
GH SS
Shown set for 35,000 ft. lbs.
TN