Position for break out – Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 User Manual

Page 28

Text mode
Original mode

Operation

Position for Break Out

6. Check that the HawkJaw Top

wrench (TW), Middle wrench
(MW) and Bottom wrench (BW)
hang straight and level when the
drill pipe is against the pipe stop.

7. If the HawkJaw wrenches(TW,

MW, BW) hang tilted forward or
backward, use the Top Tilt (TT)
button or the Bottom Tilt (BT)
button to level the wrenches.
Center the level bubble (LB).

8. If the HawkJaw wrenches(TW,

MW, BW) hang sloped to the
right or to the left, push and hold
down Winch Off (WOff) to back
the HawkJaw off the pipe. Use
Lower (L) to lower the HawkJaw
to the rig floor.

Re-

peat Step 2.

9. Make sure the Pipe stop (PS) is

against the drill pipe
connection.

NOTE

The HawkJaw performs best when it
hangs aligned with pipe.

WOff