Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 - Manual (Page 23)

Make Up
1. Press in the Grip Hold (GH)
button.
2. Press and hold Spin (S) until the
stand rotates down to the
shoulder.
3. Release Spin (S).
4. Push in and hold the wrench Grip
(G).
5. Push and hold down Torque (T).
6. Watch the Torque gauge needle
(TN).
7. When the Torque gauge needle
rises above and settles at the
desired torque (this rising above
is a normal hydraulic adjustment),
release Torque (T). Immediately
release Torque (T) button and the
wrench Grip (G) button.
7a. Note: If the desired torque is not
achieved, repeat steps 4-7.
8. Pull out the Grip Hold (GH)
button.
9. The Hawkjaw can now be
removed from the pipe.
Operation
23 Operation
SEE LOW TORQUE WARNING
SYSTEM CHECK PG. 24
G GH
T S