Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 - Manual (Page 43)

Spinner Maintenance
Maintenance & Repair 43
Maintenance
& Repair
1. Pull the Hawkjaw onto the pipe.
2. Press in the Grip Hold (GH)
button.
3. Press and hold the Spin (S)
button. While holding down the
Spin (S) button, press and hold
the Chain Oiler (CO) button for 3
seconds.
4. Release the Spin (S) button.
5. Pull out the Grip Hold (GH)
button.
Chain Lubrication
1. Position the Hawkjaw for
breakout.
Initial Steps
Notice
Spinner chain lubrication must be
done during normal operation of the
Hawkjaw. Do not run the spinner
when the Hawkjaw is not on the
pipe.
CAUTION:
This chain oiling system uses
minimal amount of hydraulic
oil from power unit - we sug-
gest you monitor hydraulic oil
level accordingly.
GH
Chain oiler nozzle
NOTE: Clean nozzle screen as required
S
CO