Hawk Industries Hawkjaw Sr. Manual 100K-2GSR Serial Numbers 101 to 120 - Manual (Page 12)

Air Requirements
1. Clean, dry air at 100 psi @ a negligible
volume.
2. On-board auto-dump air filter (Part #
061-A22). Initial on-board filter (OF)
supplied with the HawkJaw.
3. Auto-dump air filter (Part # 061-J29)
located between the air source and the
HawkJaw air supply line (A). Initial in-
line filter supplied with the HawkJaw.
4. Enough slack in the line for the
HawkJaw to move from its rest position
to the drill pipe connection to the
mouse hole connection.
12 Installation
WARNING
The HawkJaw must receive clean, dry air.
Running the HawkJaw without a Hawk
approved air filter (Part # 061-J29) voids the
warranty and shortens component life.
NOTE
Make sure the larger air filter (Part # 061-
J29) is mounted vertically with the red and
black arrows on the cannisters pointing up.
NOTE
The smaller air filter (OF) is located on
board the HawkJaw. (Part # 061-A22)
OF
A