HP CM3530 - Manual (Page 50)

Menu item Sub-menu item Sub-menu item Values and Description
AppleTalk Enable Off : Disable the AppleTalk protocol.
On (default): Enable the AppleTalk protocol.
DLC/LLC Enable Off : Disable the DLC/LLC protocol.
On (default): Enable the DLC/LLC protocol.
Security Print Sec Page Yes (default): Prints a page that contains the current
security settings on the HP Jetdirect print server.
No : A security settings page is not printed.
Secure Web For configuration management, specify whether the
embedded Web server will accept communications
using HTTPS (Secure HTTP) only, or both HTTP and
HTTPS.
HTTPS Required (default): For secure, encrypted
communications, only HTTPS access is accepted. The
print server will appear as a secure site.
HTTPS Optional : Access using either HTTP or HTTPS
is permitted.
IPSec Specify the IPSec status on the print server.
Keep : IPSec status remains the same as currently
configured.
Disable : IPSec operation on the print server is
disabled.
Reset Security Specify whether the current security settings on the
print server will be saved or reset to factory defaults.
No : The current security settings are maintained.
Yes : Security settings are reset to factory defaults.
Diagnostics Embedded Tests This menu provides tests to help diagnose network
hardware or TCP/IP network connection problems.
Embedded tests help to identify whether a network fault
is internal or external to the product. Use an embedded
test to check hardware and communication paths on
the print server. After you select and enable a test and
set the execution time, you must select
Execute to
initiate the test.
Depending on the execution time, a selected test runs
continuously until either the product is turned off, or an
error occurs and a diagnostic page is printed.
LAN HW Test CAUTION: Running this embedded test will erase
your TCP/IP configuration.
This test performs an internal loopback test. An internal
loopback test will send and receive packets only on the
internal network hardware. There are no external
transmissions on your network.
Select Yes to choose this test, or No to not choose it.
Table 2-11 Jetdirect menus (continued)
36 Chapter 2 Control panel ENWW