30 chapter 2 control panel enww – HP CM6049F MFP User Manual
Page 46
Menu item
Sub-menu item
Sub-menu item
Values and Description
Default IP
Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
Auto IP
: A link-local IP address 169.254.x.x is set.
Legacy
: The address 192.0.0.192 is set, consistent
with older HP Jetdirect devices.
DHCP Release
This menu appears if
Config Method
was set to
DHCP
and a DHCP lease for the print server exists.
No
(default): The current DHCP lease is saved.
Yes
: The current DHCP lease and the leased IP
address are released.
DHCP Renew
This menu appears if
Config Method
was set to
DHCP
and a DHCP lease for the print server exists.
No
(default): The print server does not request to renew
the DHCP lease.
Yes
: The print server requests to renew the current
DHCP lease.
Primary DNS
Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Secondary DNS
Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 Settings
Enable
Use this item to enable or disable IPv6 operation on the
print server.
Off
: IPv6 is disabled.
On
(default): IPv6 is enabled.
Address
Manual Settings: Use this item to manually set IPv6
addresses on the print server.
Enable
: Select this item and choose
On
to enable
manual configuration, or
Off
to disable manual
configuration.
Address
: Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
DHCPV6 Policy
Router Specified
: The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
Router Unavailable
: If a router is not available, the print
server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always
: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Table 2-11
Jetdirect menus (continued)
30
Chapter 2 Control panel
ENWW