HP CM6049F MFP - Manual (Page 106)

Configure TCP/IPv4 parameters
If your network doesn't provide automatic IP addressing through DHCP, BOOTP, RARP, or another
method, you might need to enter the following parameters manually before you can print over the
network:
● IP address (4 bytes)
● Subnet mask (4 bytes)
● Default gateway (4 bytes)
Input or change the IP address
You can view the current IP address of the device from the control-panel Home screen by touching
Network Address .
Use the following procedure to change the IP address manually.
1. Scroll to and touch Administration .
2. Scroll to and touch Initial Setup .
3. Touch Networking and I/O .
4. Touch Embedded Jetdirect .
5. Touch TCP/IP .
6. Touch IPV4 Settings .
7. Touch Config Method .
8. Touch Manual .
9. Touch Save .
10. Touch Manual Settings .
11. Touch IP Address .
12. Touch the IP Address text box.
13. Use the touchscreen keypad to type the IP address.
14. Touch OK .
15. Touch Save .
Set the subnet mask
1. Scroll to and touch Administration .
2. Scroll to and touch Initial Setup .
3. Touch Networking and I/O .
4. Touch Embedded Jetdirect .
5. Touch TCP/IP .
90 Chapter 6 Network configuration ENWW