Epson EQUITY 3865X/20 PLUS - Manual (Page 37)

Automatic Configuration
The Equity 386SX/20 PLUS automatically defines your system’s
memory configuration and recognizes a math coprocessor, if you
have installed one. It also detects and configures most of the
devices you have installed in your system. Therefore, you may
not need to change any default settings in the Setup program.
However, you should check each option on the Setup menu to
verify that the settings are correct for your configuration.
The computer automatically configures the 2MB of memory that
comes with your system as 640KB of base memory and 1280KB
of extended memory. If you install even more memory, Setup
configures it as extended memory also.
Starting the Setup Program
Follow these steps to start the Setup program:
1. Make sure your computer is turned off.
2. Insert the Reference diskette in drive A as shown in the
following illustration. Make sure the label is facing up and
the read/write slot is pointed toward the drive.
2-2 Running the Setup Program