Epson EQUITY 3865X/20 PLUS - Manual (Page 147)

How to Use This Chapter
The instructions in this chapter describe how to install and
remove optional Epson diskette and hard disk drives. All drives
sold by Epson for the Equity 386SX/20 PLUS are qualified and
recommended for use in this system. Your drive may look a bit
different from the one illustrated here, but you install it the
same way.
If you are installing or removing a non-Epson drive, some of
the steps may not apply to your drive; see the documentation
that came with the drive for more information.
Each section in this chapter describes a part of the process you
may need to perform. Here are the guidelines:
Before you perform any of the procedures described here,
follow the steps in Chapter 5 to remove the computer’s
cover and the subassembly.
If you are installing a hard disk drive or removing one and
leaving another in the computer, follow the steps under
“Setting the Hard Disk Drive Jumpers” on page 7-4.
If you are removing your only hard disk drive, see
“Removing a Hard Disk from the Vertical Position” on
page 7-21.
If you are installing or removing a diskette drive and you
currently have a hard disk drive installed in the vertical
mounting position, see “Removing a Hard Disk from the
Vertical Position” on page 7-21.
If you are installing or removing a diskette drive and you do
not have a hard disk drive installed in the vertical mounting
position, see “Installing or Removing a Disk Drive in the
Horizontal Position” on page 7-23.
Installing and Removing Disk Drives 7-3