Canon REALiS 4K501ST Pro AV 5000-Lumen LCoS Projector - Manual (Page 149)

149
Using the Projector on a Network
Ad
va
nc
ed
G
uid
e
Using
the
Pr
oje
ctor
on a Networ
k
* When the interval is set to 0 seconds, repeated attempts to send mail are made
(as set in [Mail resend times]) without pausing between attempts.
Mail Authentication Settings [Mail auth]
From [Mail auth], you can configure the settings for authentication of mail that is
sent when an error occurs. For the setting procedure, refer to “Network Setting”
(
P144 ).
Sending a Test Mail [Send test mail]
From [Mail] in the settings screen, you can send a test mail to the specified mail
address by clicking [Send test mail] at the bottom of the screen. The settings
cannot be changed from this screen.
Mail resend times Enter the number of times to resend
mail when an error occurred within the
range of 0 - 255 using 1-byte numbers. 3
Item Explanation Factory default setting
Mail authentication Select the mail authentication method.
If OFF is selected, the other mail
authentication settings cannot be
changed. OFF
User name Enter the user name to use for mail
authentication in 1-byte alphanumeric
characters and symbols (1 - 63
characters).
Password Enter the password for mail
authentication in 1-byte alphanumeric
characters and symbols (1 - 63
characters).
Confirm password For confirmation, enter the same
password as you entered in
[Password].
POP3 server IP
address Enter the POP3 server IP address in 1-
byte numbers. 0.0.0.0
POP3 server port
number Enter the POP3 server port number in
1-byte numbers (1 - 65535). 110
POP before SMTP
response time Enter the SMTP authentication timeout
period after POP3 authentication (unit:
milliseconds) using 1-byte numbers (0
- 9999 milliseconds). 300
Item Explanation Factory default setting