Sony ICF-506 Portable Analog FM/AM Radio - Manual (Page 32)

32
1/725, 1/1000, 1/1500, 1/2000, 1/3000, 1/4000,
1/6000, and 1/10000.
When the signal format is 2160/25p (the
BRC-X1000 only), 1080/50p, 1080/50i, or
720/50p
You can choose from 1/6, 1/12, 1/25, 1/30, 1/50,
1/60, 1/100, 1/120, 1/150, 1/215, 1/300, 1/425,
1/600, 1/1000, 1/1250, 1/1750, 1/2500, 1/3500,
1/6000, and 1/10000.
When the signal format is 2160/23.98p
(the BRC-X1000 only), 1080/23.98p
You can choose from 1/6, 1/12, 1/24, 1/25, 1/40,
1/48, 1/50, 1/60, 1/96, 1/100, 1/120, 1/144, 1/192,
1/200, 1/288, 1/400, 1/576, 1/1200, 1/2400,
1/4800, and 1/10000.
IRIS: When EXPOSURE MODE is either MANUAL
or IRIS Pri, you can choose aperture setting.
You can choose from F2.8/F3.1/F3.4/F3.7/F4.0/
F4.4/F4.8/F5.2/F5.6/F6.2/F6.8/F7.3/F8.0/F8.7/
F9.6/F10/F11.
AE SPEED: Select the adjustment speed for exposure
adjustment.
You can adjust the speed at which the camera
reaches the optimum exposure setting from 1
(Standard) to 48 (Slow). Adjust this when the
brightness of the object changes instantaneously.
This setting is enabled when MODE is FULL
AUTO, SHUTTER Pri, IRIS Pri, or GAIN Pri.
EX-COMP: Turn this ON when you want to correct
brightness of a picture whose exposure is already
automatically adjusted. This setting is enabled
when MODE is FULL AUTO, SHUTTER Pri,
IRIS Pri, or GAIN Pri. The LEVEL setting is
displayed when this is turned ON.
LEVEL: Choose a level to adjust the brightness of a
picture whose exposure is already automatically
adjusted. Choose a value from –7 to +7 for the
level.
This is not displayed when EX-COMP is turned
OFF.
GAIN LIMIT: Set the maximum sensitivity when
exposure is automatically adjusted using
sensitivity. Choose a value from 9 dB to 24 dB (in
3 dB increments) or you can turn this OFF. When
turned off, the maximum is not limited. This
setting is enabled when MODE is FULL AUTO,
SHUTTER Pri, or IRIS Pri. You cannot choose a
value smaller than the POINT POSITION setting.
GAIN POINT: When you set MIN SPEED to be
slower than the output image frame rate, the
shutter speed controls exposure based on the
GAIN POINT setting. Normally, when exposure
is controlled with sensitivity, noise becomes
prominent if sensitivity is increased to make the
image brighter. You can decrease noise by
adjusting the exposure through lower shutter
speeds to cancel sensitivity adjustments. When
you do this, turn on GAIN POINT and set the
POINT POSITION to the sensitivity at which you
want the shutter speed to change. When the
shutter speed reaches MIN SPEED for exposure
adjustment, increase sensitivity to adjust
exposure. This setting is enabled when MODE is
either FULL AUTO or IRIS Pri.
POINT POSITION: This is enabled when GAIN
POINT is turned ON. When sensitivity during
exposure adjustment reaches the value for
POINT POSITION, exposure is adjusted through
a slower shutter speed. This setting is enabled
when MODE is either FULL AUTO or IRIS Pri.
You cannot choose a value smaller than the GAIN
setting.
MAX SPEED: This sets the maximum (fastest)
shutter speed when exposure is adjusted with the
electronic shutter.
This setting is enabled when MODE is FULL
AUTO, IRIS Pri, or GAIN Pri. You cannot choose
a value slower than MIN SPEED.
When the signal format is 2160/29.97p
(the BRC-X1000 only), 1080/59.94p, 1080/
59.94i, 720/59.94p
You can choose from 1/30, 1/50, 1/60, 1/90,
1/100, 1/125, 1/180, 1/250, 1/350, 1/500, 1/725,
1/1000, 1/1500, 1/2000, 1/3000, 1/4000, 1/6000,
and 1/10000.
When the signal format is 2160/25p (the
BRC-X1000 only), 1080/50p, 1080/50i, 720/
50p
You can choose from 1/25, 1/30, 1/50, 1/60,
1/100, 1/120, 1/150, 1/215, 1/300, 1/425, 1/600,
1/1000, 1/1250, 1/1750, 1/2500, 1/3500, 1/6000,
and 1/10000.
When the signal format is 2160/23.98p
(the BRC-X1000 only), 1080/23.98p
You can choose from 1/24, 1/25, 1/40, 1/48, 1/50,
1/60, 1/96, 1/100, 1/120, 1/144, 1/192, 1/200,
1/288, 1/400, 1/576, 1/1200, 1/2400, 1/4800, and
1/10000.
MIN SPEED: This sets the minimum (slowest)
shutter speed when exposure is adjusted with the
electronic shutter.
This setting is enabled when MODE is FULL
AUTO, IRIS Pri, or GAIN Pri. You cannot choose
a value faster than MAX SPEED.
When the signal format is 2160/29.97p
(the BRC-X1000 only), 1080/59.94p, 1080/
59.94i, 720/59.94p