Sony LA-EA5 A-Mount to E-Mount Adapter - Manual (Page 33)

Using an AXS-R5/R7 33
P
repa
ra
ti
ons
You can record image/audio (AXS format) data
to the AXS (Access Memory Card System)
recorder AXS-R5/R7 (optional) by connecting
the AXS recorder to the camcorder.
Note
Attach/remove the AXS-R5/R7 while the camcorder is
turned off.
1
Press the release button of the AXS-R5/
R7 (
1 ) to pop up the ejection lever,
then raise the ejection lever ( 2 ).
2
Insert the projection of the AXS-R5/R7
into the slot on the rear of the
camcorder (
1 ), then lower the ejection
lever ( 2 ).
Notes
• Before attaching the AXS-R5/R7, make sure that
the ejection lever is raised.
• Before lowering the ejection lever, make sure that
the four hooks are attached securely. If the four
hooks are not attached securely, it may cause the
connection to be poor or damage the camcorder
and AXS-R5/R7.
3
Attach the supplied top plate (AXS-R7
only).
Note
For details about attaching the top plate, refer to the
operating instructions of the AXS-R7.
Press the release button and raise the
ejection lever, then remove the AXS-R5/R7
by pulling it out while sliding upward.
Note
Remove the AXS-R5/R7 while supporting the
camcorder by hand.
The following is the procedure for inserting into
the AXS-R5. For inserting into the AXS-R7, refer
to the operating instructions of the AXS-R7.
1
Open the cover by sliding the memory
slot cover open/close button on the top
of the AXS-R5.
Using an AXS-R5/R7
Attaching the AXS-R5/R7
Removing the AXS-R5/R7
Inserting an AXS Memory Card