ProSoft Technology RLX2-IHNF-WC - Manual (Page 63)

RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 63 of 212
June 15, 2015
LED
Description
Signal Strength
      Blinks if SD card inserted with new configuration
This is for all radio modes.
Radios in Master mode:
    No radios linked
    One or more radios linked (right LED blinking).
      DFS Channel Availability Check in progress (all LEDs blinking Amber)
Radios in Repeater or Client mode:
  No Signal

   Radio linked, Poor Signal
     Radio linked, Fair Signal 
     Radio linked, Good Signal 
Once the power cable and Ethernet cable are connected to the radio, the Power/Status
LED should illuminate green. The SPEED LED should indicate a valid wired link. The RF
Transmit and RF Receive LEDs should start to blink occasionally.
For Repeater or Client mode radios, all three Signal Strength LEDs will blink just after the
radio links to the Master’s signal but before it has been fully authenticated. Normally
this lasts only a few seconds. If it lasts longer or never turns solid it usually means the
encryption keys are not correct.
Retrieve the Default Password
If the password is unknown, the user will be unable to change the radio settings. The
user can retrieve the default password to use the software again, but will lose all the
settings that were programmed before.
RLX2-IHNF-W and RLX2-IHNF-WC Reset
1. Remove power from the radio.
2. Press the Reset button. The Reset button is located on the front of the unit just
under the ProSoft logo.