ProSoft Technology RLX2-IHNF-WC - Manual (Page 188)

RLX2 Industrial Hotspot Series
Page 188 of 212 ProSoft Technology, Inc.
June 15, 2015
Approved Antenna Table
Use the following approved antennas when the radio module is connected directly to an
antenna. Refer to Approved antennas with power amp for a table of approved antennas
with bi-directional power amplifiers.
Type Pattern Gain Connector Size (cm) Min. distance
from Body
1/2 Wave Omni 2 dB SMA-RP 7H x 1.5 20 cm
1/2 Wave art. Omni 2 dB SMA-RP 10H x 1.0 20 cm
Collinear Array Omni 3 dB SMA-RP 6H x 3.0 20 cm
Collinear Array, art. Omni 5 dB SMA-RP 19H x 1.0 20 cm
Collinear Array Omni 5 dB SMA-RP 19H x 1.0 20 cm
Collinear Array Omni 8 dB N-RP 43H x 1.6 20 cm
Collinear Array Omni 9 dB N-RP 43H x 1.6 20 cm
Collinear Array Omni 12 dB N-RP 106H x 4.0 25 cm
Patch Directional 8 dB SMA-RP 15.0H x 15.0 20 cm
Patch Directional 11 dB SMA-RP 22H x 12.7 22 cm
Patch Directional 13 dB N-RP 22H x 22 28 cm
Patch* Directional 19 dB N-RP 15.5 x 15.5 57 cm
Yagi Directional 14 dB N-RP 81L x 9.0 28 cm
Parabolic* Directional 15 dB N-RP 40H x 51W x 25D 36 cm
Parabolic* Directional 19 dB N-RP 58H x 66W x 26D 57 cm
Parabolic* Directional 24 dB N-RP 78H x 96W x 29D 100 cm
* Only allowed in a point-to-point network.
Approved Antennas in Europe/CE
The gain of the antenna connected to the main antenna port, minus the antenna cable
loss, must be less than 4 dB to stay below the 100-mW EIRP transmit power limit.
The AUX port is only used to receive; it never transmits.
Note: In France, the user is responsible for ensuring that the selected frequency channels comply
with French regulatory standards. At the time of this printing, only channels 10 through 13 can be
used in France.