ProSoft Technology RLX2-IHNF-WC - Manual (Page 189)

RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 189 of 212
June 15, 2015
Approved Antennas in Mexico
The gain of the antenna connected to the main antenna port, minus the antenna cable
loss, must be less than 12 dB to stay below the 650-mW EIRP transmit power limit.
Note: In Mexico, the user is responsible for ensuring that the selected frequency channels comply
with Mexican regulatory standards. At the time of this printing, only channels 9 through 11 can be
used outdoors (1 through 8 cannot); however, channels 1 through 11 can all be used indoors.
Approved Antennas with Power Amp
When the radio is used in conjunction with the amplifier, the antennas are limited to
antennas listed in the following table.
Type Pattern Gain Connector Size (cm) Min. distance from
Body
1/2 Wave Omni 2 dB SMA-RP 7H x 1.5 20 cm
1/2 Wave art. Omni 2 dB SMA-RP 10H x 1.0 20 cm
Collinear Array Omni 3 dB SMA-RP 6H x 3.0 20 cm
Collinear Array, art. Omni 5 dB SMA-RP 19H x 1.0 20 cm
Collinear Array Omni 5 dB SMA-RP 19H x 1.0 20 cm
Collinear Array Omni 8 dB N-RP 43H x 1.6 20 cm
Collinear Array Omni 9 dB N-RP 43H x 1.6 20 cm
Collinear Array* Omni 12 dB N-RP 106H x 4.0 25 cm
Patch Directional 8 dB SMA-RP 15.0H x 15.0 20 cm
Patch* Directional 11 dB SMA-RP 22H x 12.7 20 cm
Patch* Directional 13 dB N-RP 22H x 22 28 cm
Yagi* Directional 14 dB N-RP 81L x 9.0 28 cm
* Only allowed in a point-to-point network.