ProSoft Technology RLX2-IHNF-WC - Manual (Page 4)

RLX2-IHNF, RLX2-IHA, RLX2-IHG, RLX2-IHW
1. This equipment is Suitable For Use in Class I, Division2, Groups A, B, C, D or Non-Hazardous
Location Only.
2. WARNING – EXPLOSION HAZARD – Substitution of Any Components May Impair Suitability
for Class I, Division 2.
3. WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has been
removed or the area is known to be non-hazardous.
4. The unit is to be connected only to PoE networks without routing to the outside plant.
5. WARNING – EXPLOSION HAZARD – The SIM Card/Personality Module connection is for initial
setup and maintenance only. Do not use, connect, or disconnect unless area is known to be
non-hazardous. Connection or disconnection in an explosive atmosphere could result in
explosion.
6. Device must be powered by a Class 2 Power Source.
7. Device is an open-type and is to be installed in an enclosure suitable for the environment.
RLX2-IHNF-W
1. WARNING – EXPLOSION HAZARD – DO NOT USE IN CID2 HAZARDOUS LOCATIONS.
2. WARNING – DO NOT CONNECT OR DISCONNECT WHEN ENERGIZED.
3. This unit is to be connected only to PoE networks without routing to an outside plant.
4. Device must be powered by a Class 2 Power Source.
5. Make sure proper grounding is secured.
6. Unit does not comply to the cable assy requirements of ISA 12.12.01 but does comply with
the ATEX standards IEC60079-0 & IEC60079-15. In ATEX environments, do not
connect/disconnect unless area is known to be non-hazardous.
RLX2-IHNF-WC
1. SUITABLE FOR USE IN CLASS I, Division 2, GROUPS A, B, C, and D HAZARDOUS LOCATIONS, or
NON-HAZARDOUS LOCATIONS ONLY.
2. WARNING – EXPLOSION HAZARD – SUBSTITUTION OF ANY COMPONENTS MAY IMPAIR
SUITABILTY FOR CLASS I, DIVISION 2.
3. WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS
BEEN REMOVED OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
4. This unit is to be connected only to PoE networks without routing to the outside plant.