ProSoft Technology RLX2-IHNF-WC - Manual (Page 105)

RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 105 of 212
June 15, 2015
where the current Parent’s RSSI goes below the threshold,
the Next Parent is in range. Otherwise, the roam will fail.
The main point to remember is that a Child Repeater will not
roam while its current Parent’s RSSI is higher than the current
Roam Threshold value. In the case where a Next Parent is not
being advertised, or the Next Parent is on the same channel,
then the Cost comparison to determine when to roam only
occurs once the current Parent’s RSSI is below the Roam
Threshold. This allows the roam point to be controlled when
a mobile platform travels a known path.
Parent Margin When checked, this enables advertising of the Parent Margin
that a Child Repeater should use. This Parent Margin
overrides the Child Repeater’s equivalent setting, but only
while the Child Repeater is associated to this unit. If the
Parent is not advertising a Parent Margin, then the Child
Repeater will revert to using its own configured value. (see
the Parent Link Settings help page description of Parent
Margin).
Save Saves your changes and updates the radio configuration.
Cancel Discards your changes without updating the radio
configuration.
Security Settings
The Security Controls shown in the center panel will vary depending on the values of the
following controls”

Security Mode

802.11 Mode

Master or Repeater/Client
As each of the Mode controls are changed on the web page, the set of controls in the
Security panel will automatically change to selections applicable to the selected mode.
Note: The controls will change to allow you to fully configure the Security Settings
before Applying the Changes.