ProSoft Technology RLX2-IHNF-WC - Manual (Page 27)

RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 27 of 212
June 15, 2015
R L X 2 Q
U I C K
S
E T U P
This section describes how to setup RLX2 radios in a minimal configuration before
deploying them in the permanent installation. It will help verify the radios are
operational along with getting familiar with basic configuration procedures.
Note that the procedures described in this section assume the radios are in their default
configurations as shipped by ProSoft. If that is not the case, reset the radios to factory
defaults before attempting these procedures.
In any given network, there must be one radio acting as a Master, and the other radios
will be configured as Repeaters or Clients. Generally there is only one Master radio per
network.
Because most wireless networks consist of one Master radio and multiple Repeaters, all
RLX2 radios are shipped from ProSoft pre-configured as Repeaters. Hence our first task
is to configure one radio as the network Master.
IMPORTANT: If a ProSoft Power adapter RL-PS007-2 (supplied with the RLX-IHBTK Bench Test
Kit) is not present, see instructions on wiring the power connector in this manual.