ProSoft Technology 5201-DFNT-DNPS - Manual (Page 63)

Reference ProLinx DNPS ♦ ProLinx Gateway
User Manual DNP 3.0 Slave
ProSoft Technology, Inc.
Page 63 of 86
December 1, 2009
DNP Analog Output Data
This data type stores analog values sent from the DNP master unit to the module
and the other protocol with a data range of 0 to 65535 or -32768 to 32767. The
size of this data area is determined from the configuration parameter Analog
Outputs. These data are transferred from the module to the other protocol using
the write operation. Therefore, these data are read-only for the other protocol, as
the other protocol cannot directly alter these values in the module. It is the
responsibility of the DNP master unit to maintain this data. For example, if the
DNP master sends a value of 3405 to the module for a specific point, the value
will be stored in the module until changed by the master.
The following illustration describes data flow for the analog output data.