ProSoft Technology 5201-DFNT-DNPS - Manual (Page 43)

Reference ProLinx DNPS ♦ ProLinx Gateway
User Manual DNP 3.0 Slave
ProSoft Technology, Inc.
Page 43 of 86
December 1, 2009
3.1.3 Functional Specifications - DNP 3.0 Slave
The DNP 3.0 Slave driver provides extensive support for Slave implementations
of the protocol. The serial port on the gateway is user-configurable to support the
DNP 3.0 protocol (Slave, Error Checking, Baud rate, and so on).
General Parameters
Internal Database Binary Inputs: 0 to 500 word count
Analog Inputs: 0 to 500 points
Counters: 0 to 250 points
Binary Outputs: 0 to 200 word count
Analog Outputs: 0 to 500 points
Binary Input Events: 0 to 100 event buffer
Analog Input Events: 0 to 100 event buffer
Communication parameters Baud Rate: 110 to 115K baud
Stop Bits: 1
Data Size: 8 bits
Parity: None
RTS Timing delays: 0 to 65535 milliseconds
DNP Mode DNP 3.0 Slave - Level 2
DNP Slave
Node address 0 to 65534 (software selectable)
3.1.4 Hardware Specifications
Specification Description
Power Supply 24 VDC nominal
18 to 32 VDC allowed
Positive, Negative, GND Terminals
2.5 mm screwdriver blade
Current Load 500 mA max@ 32 VDC max
Operating Temperature -20 to 50°C (-4 to 122°F)
Storage Temperature -40 to 85°C (-40 to 185°F)
Relative Humidity 5% to 95% (non-condensing)
Dimensions Standard: 5.20 H x 2.07 W x 4.52 D inches
(13.2 cm H x 5.25 cm W x 11.48cm D)
Extended: 5.20 H x 2.73 W x 4.52 D inches
(13.2 cm H x 6.934 cm W x 11.48cm D)
LED Indicators Power and Module Status
Application Status
Serial Port Activity LED
Serial Activity and Error LED Status
Configuration
Serial Port DB-9M RS-232 only
No hardware handshaking