ProSoft Technology 5201-DFNT-DNPS - Manual (Page 48)

ProLinx DNPS ♦ ProLinx Gateway Reference
DNP 3.0 Slave User Manual
Page 48 of 86
ProSoft Technology, Inc.
December 1, 2009
Collision Avoidance (DNP modules only)
The RTS line is controlled by the RTS on and off parameters set for the port. If
the CTS line is used (usually only required for half-duplex modems and not
defined for use in the DNPS specification), the RTS and CTS lines must either be
connected together or connected to the modem. The following illustration shows
the cable required when connecting the port to a modem.
If collision avoidance is used in a point-to-point connection on the RS-232
interface, the following cable should be used.