ProSoft Technology MVI56E-MNETC - Manual (Page 176)

Guide to the MVI56E-MNETC User Manual MVI56E-MNETC ♦ ControlLogix Platform
User Manual Modbus TCP/IP Client Enhanced Communication Module
Page 176 of 183 ProSoft Technology, Inc.
February 3, 2013
5.8.4 Downloading the Sample Program to the Processor
Note: The key switch on the front of the ControlLogix module must be in the
REM
position.
1 If you are not already online to the processor, open the C OMMUNICATIONS
menu, and then choose D OWNLOAD . RSLogix will establish communication
with the processor.
2 When communication is established, RSLogix will open a confirmation dialog
box. Click the D OWNLOAD button to transfer the sample program to the
processor.
3 RSLogix will compile the program and transfer it to the processor. This
process may take a few minutes.
4 When the download is complete, RSLogix will open another confirmation
dialog box. Click OK to switch the processor from PROGRAM mode to RUN
mode.
Note: If you receive an error message during these steps, refer to your RSLogix
documentation to interpret and correct the error.