ProSoft Technology MVI56E-MNETC - Manual (Page 142)

Guide to the MVI56E-MNETC User Manual MVI56E-MNETC ♦ ControlLogix Platform
User Manual Modbus TCP/IP Client Enhanced Communication Module
Page 142 of 183 ProSoft Technology, Inc.
February 3, 2013
5.3.3 Client Command List
In order for the Client to function, the module's Client Command List must be
defined in the MNET Client x Commands section of the configuration. This list
contains up to 16 individual entries, with each entry containing the information
required to construct a valid command. This includes the following:
 Command enable mode: (0) disabled, (1) continuous or (2) conditional.
Conditional enabling applies only to write commands.
 IP address and service port to connect to on the remote server
 Slave Node Address
 Command Type - Read or Write up to 100 words per command
 Database Source and Destination Register Address - Determines where data
will be placed and/or obtained
 Count - Select the number of words to be transferred - 1 to 100
 Poll Delay - 1/10
th seconds
For information on troubleshooting commands, see Client Command Errors
(page 106).