ProSoft Technology MVI56E-MNETC - Manual (Page 103)

MVI56E-MNETC ♦ ControlLogix Platform Diagnostics and Troubleshooting
Modbus TCP/IP Client Enhanced Communication Module User Manual
ProSoft Technology, Inc. Page 103 of 183
February 3, 2013
Controller Tag Data Type Description
PassCnt INT This value is incremented each time a complete
program cycle occurs in the module.
ProductVersion INT Product version
ProductCode INT[2] Product code
BlockStats.Read INT Total number of read blocks transferred from the
module to the processor
BlockStats.Write INT Total number of write blocks transferred from the
processor to the module
BlockStats.Parse INT Total number of blocks successfully parsed that were
received from the processor
BlockStats.Event INT Total number of Event Command blocks received from
the processor
BlockStats.Cmd INT Total number of Command Control blocks received
from the processor
BlockStats.Err INT Total number of block errors recognized by the module
CmdBits[x] INT Displays enabled or disabled status of all 16
commands in the Client x Command List for each
Client
ClientStatsTrigger BOOL Initiates request for Client Status block from module
when set to 1
ClientID INT Specifies Client (0-29) to request status data from
ClientStatus[x].CmdReq INT Total number of command list requests sent from
Client
ClientStatus[x].CmdResp INT Total number of command list responses received by
Client
ClientStatus[x].CmdErr INT This value is incremented each time an error message
is received from a remote unit or a local error is
generated for a command.
ClientStatus[x].Requests INT Not used
ClientStatus[x].Responses INT Not used
ClientStatus[x].ErrSent INT Not used
ClientStatus[x].ErrRec INT Not used
ClientStatus[x].CfgErrWord INT Configuration Error Word - This word contains a
bitmap that indicates general module configuration
errors.
ClientStatus[x].CurErr INT Most recent error code recorded for the Client
ClientStatus[x].LastErr INT Previous most recent error code recorded for the
Client
CmdErrorList[x] INT Command error code for each command (0-15) on the
specified Client's command list
EventSeqCmdPending.Trigg
er BOOL Set to 1 to trigger the command queue status data
request.
EventSeqCmdPending.Clien
t[x]_QueueCount SINT Number of Event sequence commands for which
status has not yet been retrieved
EventSeqCmdPending.Clien
t[x]_WaitingMsgs SINT Total number of commands waiting in the command
queue
EventSeqCmd.Trigger BOOL Set the value of this tag to 1 to trigger the Event
Sequence Command block request.
EventSeqCmd.ClientID INT Specifies Client (0-29) to request status data from.