ProSoft Technology MVI56-101S - Manual (Page 68)

Configuring the MVI56-101S Module MVI56-101S ♦ ControlLogix Platform
User Manual IEC 60870-5-101 Slave Communication Module
Page 68 of 193 ProSoft Technology, Inc.
August 2, 2011
2.19 [C_SE_NC_1]
This section defines the short-float setpoint database. This information is sourced
from the remote Master and is transferred to the database.
You can associate a command with a monitored single-point database value to
coordinate the command/monitor operation. You must enter the correct M
ONITOR
P OINT # and M ONITOR DB ADDRESS values in the table. If the R EQUIRE S ELECT
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:
 P
OINT #
 DB
ADDRESS
 M
ONITOR P OINT #
 M
ONITOR DB ADDRESS
 R
EQUIRE S ELECT
Each point consumes two words. The DB A DDRESS value corresponds to the
double-word offset in the database.
The DB ADDRESS should be located in a database area that is being constantly
moved from the Master to the module.
For additional information on how to set these parameters, see the Reference
chapter of this manual.