ProSoft Technology MVI56-101S - Manual (Page 65)

MVI56-101S ♦ ControlLogix Platform Configuring the MVI56-101S Module
IEC 60870-5-101 Slave Communication Module User Manual
ProSoft Technology, Inc. Page 65 of 193
August 2, 2011
2.16 [C_BO_NA_1]
This section defines the Command 32-bit Bitstring Point database. This
information is sourced from the remote Master and is transferred to the database.
You can associate a command with a Monitored Double-Point database value to
coordinate the command/monitor operation. You must enter the correct Monitor
Point # and Monitor DB Address values in the table. If the Require Select
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:
 Point
#
 DB Address
 Monitor Point #
 Monitor
DB Address
Each point is four 8-bit bytes and the DB Address value corresponds to the
double word offset in the module memory database.
The DB address should be located in a database area that is being constantly
moved from the Master to the module.
For additional information on how to set these parameters, see the Reference
chapter of this manual.