ProSoft Technology MVI56-101S - Manual (Page 63)

MVI56-101S ♦ ControlLogix Platform Configuring the MVI56-101S Module
IEC 60870-5-101 Slave Communication Module User Manual
ProSoft Technology, Inc. Page 63 of 193
August 2, 2011
2.14 [C_DC_NA_1]
This section defines the double point command database. This information is
sourced from the remote Master and is transferred to the database.
You can associate a command with a monitored double point database value to
coordinate the command/monitor operation. You must enter the correct M
ONITOR
P OINT # and M ONITOR DB ADDRESS values in the table. If the R EQUIRE S ELECT
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:
 P
OINT #
 DB
ADDRESS
 M
ONITOR P OINT #
 M
ONITOR DB ADDRESS
 R
EQUIRE S ELECT
Each point consumes two bits. The DB A DDRESS value corresponds to the bit
offset in the database.
The DB ADDRESS should be located in a database area that is being constantly
moved from the Master to the module.
For additional information on how to set these parameters, see the Reference
chapter of this manual.