PLANET ADN-4000 - Manual (Page 80)

Current Settings
Factory Default Settings
If you wish to restart the router using the factory
default settings (for example, after a firmware
upgrade or if you have saved an incorrect
configuration), select Factory Default Settings to
reset to factory default settings. Otherwise, you
can select Current Settings. You may also reset
your router to factory settings by holding the
DEFAULT button on the back panel of your
router in for 10-12 second while the router is
turned on.
3.7.5 Diagnostics
Go to Maintenance->Diagnostics to do system restart.
This page allows you to diagnose the connectivity of the LAN and WAN network.
3.8 Status
3.8.1 Device Info
Go to Status->Device Info to check system information.
The Device Info screen is a tool that you use to monitor your ADSL Router. It shows
the Firmware Version, WAN, LAN, and MAC address information. Note that these
fields are read-only and are not meant for diagnostic purposes. Except the Virtual
80