PLANET ADN-4000 - Manual (Page 32)

The following table describes the labels in this screen.
Parameter Description
IP Address Enter the IP address you wish to use with your LAN here.
IP Subnet Mask Enter the IP subnet mask you wish to use with your LAN here.
Dynamic Route Select the Routing Information Protocol (RIP) you wish to use
from the dropdown list and the direction you want from the
dropdown list. The RIP and direction options are described
below.
Multicast Select the multicast protocol you wish to use from the
dropdown list.
3.4.2.2 DHCP Server
Dynamic Host Control Protocol (DHCP), when enabled, gives out IP addresses to a
device that requests an IP address to be logged on to the network as it boots up. A
device must be configured as a DHCP client to obtain the IP address automatically. The
DHCP address pool contains the range of the IP address that will automatically be
assigned to the clients on the network.
The following table describes the labels in this screen.
Parameter Description
DHCP Select whether DHCP is Disabled, Enabled or Relay.
32