PLANET ADN-4000 - Manual (Page 45)

Device Show the interface that go to the next hop (router),
such as LAN port.
Use The counter for access time.
Edit Edit the route, this icon is not shown for system
default route.
Drop Drop the route, this icon is not shown for system
default route.
[Add Route]
Select this option to set Static Routing information.
The following table describes the labels in this screen.
Parameter Description
Destination IP Address:
This parameter specifies the IP network address
of the final destination of packets routed by this
rule.
IP Subnet Mask Enter the subnet mask for this destination.
Gateway IP Address Enter the IP address of the gateway. A gateway
does the actual forwarding of the packets. Enter
the gateway’s IP address in the field or select
which PVC you wish to act as a gateway.
Metric Metric represents the "cost" of transmission for
routing purposes. IP Routing uses hop count as
the measurement of cost, with a minimum of 1 for
45