PLANET ADN-4000 - Manual (Page 78)

information.
A Network Time Protocol (NTP) server can
automatically set the router time for you. If you use
an NTP server, you will only need to select your
time zone. If you manually set the time, you can
enable Daylight Saving. The router will
automatically adjust when Daylight Saving goes
into effect.
When you are done making changes, click on SAVE to save your changes or on
CANCEL to exit without saving.
3.7.3 Firmware
Go to Maintenance -> Firmware to upgrade the firmware.
You can upgrade the firmware of the router in this page. Make sure the firmware you
want to use is on the local hard drive of the computer. Click on Browse to browse the
local had drive and locate the firmware to be used for the update. Then press
UPGRADE to upload new Firmware.
It might take several minutes, don’t power off it during upgrading. Device will
restart after the upgrade!!
After a success upload, the system automatically restarts. Please wait for the device to
finish restarting. This should take about 2 minutes or more. You need to log in again if
you want to access the device.
78