PLANET ADN-4000 User Manual

Page 29

The following table describes the labels in this screen.

Parameter Description

Username

Enter your username for your PPPoE/PPPoA connection.

Password

Enter your password for your PPPoE/PPPoA connection.

Encapsulation

Select your encapsulation type from the dropdown list.

Bridge Interface

Select whether the Interface will be Activated or Deactivated.

Connection

Select whether your connection is always on or if it connects on

demand. If on demand, specify how many minutes the

connection may be idle before it disconnects.

TCP MSS Option

Enter the TCP MSS you wish to use here.

Get IP Address

Choose whether the ROUTER obtains the IP address statically

or dynamically.

Static IP Address

Enter the static IP address here. Only if you chose Static above.

IP Subnet Mask

Enter the IP subnet mask here. Only if you chose Static above.

Gateway

Enter the gateway here. Only if you chose Static above.

NAT

Select whether NAT is Enabled or Disabled.

Default Route

Select whether this PVC will be the default route for Internet

data.

TCP MTU Option

Enter TCP MTU Value here.

Dynamic Route

Select the RIP type and direction from the dropdown lists.

Multicast

Select the multicast protocol you wish to use from the dropdown

list.

Connection Setting

: For PPPoE/PPPoA connection, you can select Always on or

Connect on-demand. Connect on demand is dependent on the traffic. If there is

no traffic (or Idle) for a pre-specified period of time, the connection will tear down

automatically. And once there is traffic send or receive, the connection will be

automatically on.

IP Address

: For PPPoE/PPPoA connection, you need to specify the public IP

address for this ADSL Router. The IP address can be either dynamically (via

DHCP) or given IP address provide by your ISP. For Static IP, you need to specify

the IP address, Subnet Mask and Gateway IP address.

NAT

: Select this option to Activate/Deactivated the NAT (Network Address

Translation) function for this VC. The NAT function can be activated or

deactivated per PVC basis.