PLANET ADN-4000 - Manual (Page 35)

3.4.3 Wireless Configuration
Go to Interface -> Wireless to setup the wireless parameters.
This section introduces the wireless LAN and some basic configurations. Wireless
LANs can be as simple as two computers with wireless LAN cards communicating in a
peer-to-peer network or as complex as a number of computers with wireless LAN cards
communicating through access points which bridge network traffic to the wired LAN.
3.4.3.1 Access Point Settings
The following table describes the labels in this screen.
Parameter Description
Access Point
Default setting is set to "Activated". If you do not have
any wireless, both 802.11g and 802.11b, device in your
network, select "Deactivate".
Channel The range of radio frequencies used by IEEE 802.11b/g
wireless devices is called a channel. Select a channel
from the drop-down list box.
Beacon interval The Beacon Interval value indicates the frequency
35