PLANET ADN-4000 - Manual (Page 12)

Select a suitable place on the network to install the ADN-4000.
NOTE For best Wireless reception and performance, the ADN-4000 should be
positioned in a central location with minimum obstructions between the
ADN-4000 and the PCs.
Also, if using multiple Access Points, adjacent Access Points should use
different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the ADN-4000. Both
10Base-T and 100Base-TX connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable. Any
LAN port on the ADN-4000 will automatically function as an "Uplink" port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADN-4000 (the RJ-11
connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the ADN-4000. Use only the power adapter provided.
Using a different one may cause hardware damage.
5. Check the LEDs
• The PWR LED should be ON.
• The WLAN LED should be flash, when wireless AP is ready.
• The ADSL LED should be ON if ADSL line is connected.
• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is also
ON.)
Note: You must use the power adapter shipped along with the router, do NOT use any other power
adapter from other sources.