PLANET ADN-4000 - Manual (Page 30)

[Dynamic Route]
RIP (Routing Information Protocol): Select this option to specify the RIP version,
including RIP1, RIP2-B and RIP2-M. RIP2-B & RIP2-M are both sent in RIP-2 format,
the difference is that RIP2-M using Multicast and RIP2-B using Broadcast format.
RIP Direction: Select this option to specify the RIP direction.
ƒ None is for disabling the RIP function.
ƒ Both means the ADSL Router will periodically send routing information and
accept routing information then incorporate into routing table.
ƒ IN only means the ADSL router will only accept but will not send RIP packet.
ƒ OUT only means the ADSL router will only sent but will not accept RIP packet.
[Multicast]
IGMP (Internet Group Multicast Protocol): It is a session-layer protocol used to
establish membership in a multicast group. The ADSL supports both IGMP version
IGMP-v1 & IGMP-v2. Select None to disable it.
Your ISP should provide the above information. Note that you must enter the user
name exactly as your ISP assigned it. If the assigned name is in the form of
user@domain where domain identifies a service name, enter it exactly as given.
(4) Bridge Mode
The modem can be configured to act as a bridging device between your LAN and your
ISP. Bridges are devices that enable 2 or more networks to communicate as if they are 2
segments of the same physical LAN. Please set the Connection type.
The following table describes the labels in this screen.
Parameter Description
Encapsulation Select your encapsulation type from the dropdown list.
30