PLANET WNAP-7206 - Manual (Page 65)

User Manual of WNAP-7206
-57-
directly connected to the LAN port of the AP, please make sure that its
adapter supports Tag function, or this PC will not be able to access the
AP.
 SSID
Enter a value of up to 32 characters. The same Name (SSID) must be
assigned to all wireless devices in your network. In Multi-SSID
operation mode, enter SSID for each BSS in the field "SSID1" ~
"SSID4".
 VLAN ID
The ID of a VLAN. Only in the same VLAN can a wireless PC and a
wired PC communicate with each other. The value can be between 1
and 4095. If the VLAN function is enabled, when AP forwards packets,
the packets out from the LAN port will be added with an IEEE 802.1Q
VLAN Tag, whose VLAN ID is just the ID of the VLAN where the
sender belongs.
 Region
Select your region from the pull-down list. This field specifies the
region where the wireless function of the Device can be used. It may
be illegal to use the wireless function of the Device in a region other
than one of those specified in this filed. If your country or region is not
listed, please contact your local government agency for assistance.
 Transmit Power
You can limit the Transmit Power of the Device through this field. You
can select one of the options listed as the below items.
 Channel
This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice
interference problems with another nearby access point. If you select
auto, then the Device will select the best channel automatically.
 Mode This field determines the wireless mode which the Device works on.
 Max Tx Rate
You can limit the maximum tx rate of the Device through this field. You
can select one of the options listed as the below items.
 Enable Wireless Radio
The wireless radio of the Device can be enabled or disabled to allow
wireless stations access. If enabled, the wireless stations will be able
to access the Device; otherwise, wireless stations will not be able to
access the Device.
 Enable SSID Broadcast
If you select the Enable SSID Broadcast checkbox, the wireless
Router will broadcast its name (SSID) on the air.
 Enable DFS Check Enable DFS to enable DFS function.
 Save Click the Save button to save your settings on this page.